Recent content by Craftsman Garage

ok please do

to slomo above

could you post a picture of your carburetor?

photo 1(1).jpg 146.6 KB · Views: 8 photo 2(1).jpg 159.6 KB photo 3(1).jpg 130.1 KB photo 4.jpg 103.6 KB · photo 5.jpg 172.4 KB

1. yes 2. new to me but used 3.ok 4.no so that is is easier to start .

thank you got it started, although I have another problem, feels like its running lean, do you know the correct carb adjust meant? only runs on choke and on fast throttle it shuts off. Thanks

hi

MODEL ___ TYPE ___ CODE_ 90212 ___ 0216 01 __91120503

yeah hasn't ran in a few years or something, just inherited it

MODEL ___ TYPE ___ CODE_ 90212 ___ 0216 01 __91120503

oh ok

ok

how do I figure out if its hydro locked?? I'm all new to this stuff

how do I fix a hydro locked engine

MTD edger with a 3 hp briggs, how do I fix a seized briggs?????? very hard to pull. idk why it seized? the cord pulled fine yesterday.

MTD edger with a 3 hp briggs, how do I fix a seized briggs?????? very hard to pull.

can you turn over engine with your hand?

*HST

what is hot, then I could help you

I had a craftsman and it started like that so you might have to rebuild the engine and or get a new head gasket. white also means burning oil

do you know how many hours on it? did you buy it new yourself?

believe me I've had my share of a bad gasket, and 2 in five people have get a broken head bolt, diy projects are not the way to fix some things like that. have the pros do it.

Add coolant to the right amount, and drain and add new oil, does your John Deere have a oil filter? if so replace that as well. Use 10W-30, and oil capacity is 1.9 quarts. And that should fix your problem, if not it is a blown head gasket. And at that point just take it in to a repair shop to...

??

yes you absolutely don't want to ever adjust the flywheel on one of those engines