Recent content by ColdSteel777

well i finished assembling the motor and its running on this config: block: 098902 piston: 098902 oil thrower: 098902 cyl head: 098902 crank: 10G902 conrod:10G902 all the other parts taken from 098902 (feul tank , exhaust , etc from 098902) motor is running fine :)

actually rods are same length , pistons are same bore , distance from gudgeon pin to top of pistons are the same. only difference is older piston weighs 200 grams and newer piston weighs 175 grams. I have had to use the heavier piston as it had the best rings. motor is assembled and turns fine...

This is the piston from the working engine the one with the vane and worn out valve guides

hi , Im not going to use the air vane block , that one has the worn valve guides. it turns out the piston with the flat side skirts is the newer one and its the one that came with the crank , although the flat skirt piston has been used a lot more than the completely round one , it has some...

Hi guys my lawn mower engine ran without oil and it threw a connecting rod so I have managed to find the same motor although a few parts are different namely the pistons and oil splasher and the one block has a lever inside that connected to the carburettor on the outside that would be the used...