Recent content by chrisd1972vw

Thanks for the diagram. I installed a brand new harness from John Deere with all new safety switches (due to the previous damage from mice.) Now, I am back to square one for no start. You can jump across the starter and it'll turn over but it will not start.

I have a 335E zero turn that is giving me a fit. I had serviced it and was pulling it out to clean it up. Well, it shut down never to restart. The electrical system was dead. Upon further inspection I found the wiring harness had been destroyed by mice. They had stripped about 60-70% of the...

I have discovered damage by mice. The thing that is throwing me is when you just turn the key on, the hour meter will not even turn on. I'm running the wires now to make sure something isn't broken or grounded out. Thanks for the input.

The safety switch on the seat is good. The handles switches tested good, but the wires have been damaged by mice (as has a lot of the wiring harness. ) The PTO switch was off.

I'm running the wires now. It ran after I serviced it. It ran to where it was parked.

I have an issue and need some help. I serviced a very abused Z335E. It ran fine after I was finished and I parked it in anticipation of washing it to returning it to the customer. Now, nothing. The battery is fully charged. I found a blown fuse and changed it. I also found the switch had been...

I have tried switching back to the factory ignition switch as well, but it's still clicking the fuel shut off. But, thanks for looking for a wiring diagram!

I have a Bad Boy ZT I am working on that has major electrical issues. The customer mowed with it and said it was cutting out the last time before he parked it. When he went to start it, it would do nothing. When I went to pick it up the battery was dead, so I put a battery in it and still...

Hey, got a question. We have a Snapper S200 in the shop. We originally drained the fuel tanks due to water in the fuel. Customer took it home, mowed and it acted up again. Now, it'll no turn over with the key, but if you jump it across the solenoid it will start. So far I have checked each...