Recent content by Bobby Boyd

Anyone using the mulching Kit? If so how do you like? Can it be left on all season? -bobby

Well, I turf tiger started right up today then after mowing for about 20 minutes i parked it. I got on it to start it up after about an hour and when I turned the key nothing happened. And yes, brake was, seat was down and I was sitting on it, control levers were out and deck was up. Any ideas...

Can someone post a picture of a scag turf tiger interlock switch that is works off the control arm? Thanks, -bobby

I have a scag turf tiger 61 inch cut. How do I remove the cover that has the electrical connections? The cover that the key goes into. The one that has the throttle and choke levers. There must be someone that has had to replace the pto switch at one time or another. In order to do so one...

I had my turf tiger serviced last fall. Today I pulled out the pto for the first time and the blades did not engage. I pushed it in and pulled again and they did engage but were slow to spin up to speed. After mowing a little bit I stopped and pushed the pto off and on and the blades started up...

I have a 61 inch turf tiger. How do I change the deck belt? What releases the belt tension? Thanks, -bobby

Well...I've got a ton or two of oak leaves that need to be mulched. How good are the eliminator blades when used with the block off plate? I don't have the hurricane mulch system. -bobby

Well...I sent my turf tiger in for service on Thursday and they brought it back on Friday. After backing it off the trailer the guy went to park it and upon pulling back the break it made a loud and i mean loud screeching noise. He immediately dropped the brake off. Upon putting the break on...

My friend bought a new tiger cat and discovered it doesn't have a gas gauge. Is is normal? -bobby

I finally was able to get grease into the zerk nearest the deck and see what i was doing at the same time. Lowering the deck helped. Previous post on here helped alot also, especially on how to move the pto shaft so I could see the zerk. Thanks to everyone who helped, bb

This is question if or Mackie but anyone is welcome to chime in. I am thinking about getting the mojack for my turf tiger (for cleaning underneath) . The only problem is that my garden shed is not large enough toleave it free standing and would have to be shelved after each use. How much...

This question is for Mackie but others are welcomed to reply of course. What do you think of using compressed air to clean the main air cleaner element by blowing air from inside out? I have a tool sold by Gempler's for doing just this. However, manual says not to use pressurized air to clean...

Having researched for months have decided that the mojack pro is probably the best and safest way to lift my turf tiger to clean underside of deck. I would appreciate hearing any comments yea or nay on the subject. One thing that is somewhat bothersome is the storage of the unit. I would like to...

It's unfortunate that manuals are written by engineers and people that build the machines and not by someone that has actually used and maintained them. For example, under lubrication section 7.1 it has lubrication interval for PTO spindle as "40 hours/Weekly". Which is it? Also what grease are...

What type of grease do you guys use on the spindles? -bobby