Recent content by blackchevy3de

I only found this craftsman Tecumseh 143.630012 16 hp

does anyone have a part number for a good replacement carb

I have this old tractor with 16hp motor and 48"deck ,has hi and lo and 3 speed trans , can someone tell me the rite gear to be in to mow with it

I have a craftsman gt5000 model 917-276101. tractor seemed to lose power going up hill,so I replaced drive belt, with one from sears that I had in package for about ten years, its a light brown belt its 1/2 by 82 1/2 it seems better but not right .whats the best belt to use ,and how much tension...

my trimmer has new carb, fuel lines,and vent and I still have the same problem , starts great and runs strong for about 30 mins, then engine starts to lose power and shake, if I turn it off for a hour or so and restart its fine for another 30 or some mins ps I also changed gas cap, im...

I have a new battery in tractor and checked the voltage at full wide open, and reads 12volts, I checked the alternator wires ac volts read 29acv,believe that to be good, but I cannot find the reg, can someone tell me wear it is , and what the voltage should be, I don't think this means anything...

My Honda has the white lever auto return choke "16610-z2d-802" the lever goes from choke to open way to fast is their anything I can do to slow it down.

I have a shindiawa trimmer with a blue case and no model or serial number, trimmer has a straight shaft and lever lock, I can only make out a 7 in the model number, my question is what years did they make them with the blue case, or can someone tell me models that used the blue case, Thanks::frown:

I have a 10.5 b&s motor with electric start, with engine running and I walk over to mower with my meter in hand to check charging system,with meter on volts it starts bouncing like crazy , ive disconnected the alt wires and still bouncing ,driving me crazy, next I took a pair of upper cables...

my mower starts great and runs fine at idle and mid way but at full wide open its surging, don't want to drill out jet .

Ihave a self propelled md 8073 im looking for the drive control lever from the wheel to the control rod, and the parts that hold the two together thanks

I HAVE A HUSQVARNA 44 CHAIN SAW WITH A SERIAL # 6141412, WITH A BLACK TOP COVER, WANTING TO KNOW YEAR IT WAS BUILT TO BUY PARTS, CAN SOMEONE HELP.THANKS

I HAVE THIS GRAVELY ZERO TURN, I BELIEVE ITS A 1995, HAS A KOHLER CV20, 20 HP V TWIN MOTOR, WOULD ONLY RUN ON FULL CHOKE, CLEANED CARB,AND IT RAN GREAT FOR 5 HOURS,THEN STALLED AND AGAIN WILL ONLY RAN ON CKOKE, THIS TIME I REMOVERED THE GAS TANK AND FLUSHED IT OUT, IT REALLY WASNT BAD, I THEN...

I have this motor on my mower is there a tool to remove the seat from the carb its a walbro or can you tell me how its removed that's. jim

I have a nice running driving 13 hp Honda 2013 its automatic, the trouble is when mowing and I step on the brake the shifter will not return to neutral unless I move it . also can you tell me what this tractor is worth its in really good shape ,ive moved and im going to need a bigger tractor...