Recent content by benali10

I have tried new plug, but not re recently. Its never really run that well. But has recently deteriorated to stalling and even back firing. Like I say just fitted new carb, but no real improvement. I've done the obvious like filters etc

123437 0170 e1

Its a 2003 briggs, where is the number located? I havent a pic atm, but will add later when home, but believe me it is black!

Hi, I have a 24inch atco with a b&s intek pro 206 engine. I just cannot seem get the engine to run nicely. The usual is it runs for a bit, until it gets warm and then it starts stalling as you put load on it. I have since put a brand-new carb on it. It runs a little better but still seems very...

I have just fitted a new plastic drive gear and within 10 minutes the gear chewed its way off its internal bush! You will see from the photo that the shaft which holds the larger pulley wheel sits below the face of the wheel so that when the cover shroud is attached and you tighten the bolt it...