Recent content by beatsal

Did all that, starts OK. Please answer my orig question i.e. what attached to the link I mentioned earlier.

Got it, stamped above SP as you said: Model 95902 Type 3107 01 Code 95051705

Looks like the plate with the code/serial is missing. All it says is 3.5 hp classic

My 3.5 hp lawnmower has a link which controls the inlet opening to the carb. This link as a spring link to the speed feedback and the throttle lever feedback but there is no connection to the throttle. See the pic attached. Not sure how to attach the link so as to be able to control the throttle.

Thanks, it worked! Just wondering - by pushing the rubber priming bulb, how is the fuel sprayed i.e. push bulb - pressure reduces, gas from tank gets sprayed. Intuitively, by pressing the bulb, shouldn't the pressure incresae momentarily?

Thanks will take a good look tomorrow (dark now)

Thanks but being an old one could not find model so will have to try any ideas you have

It says B & S Classic, no model #. It starts for a second if I do as you said i.e. pour gas into intake. I can send a pic if it helps

My lawn mower engine just won't start. Bought a new diaphragm and gasket for the carb, no luck. Iput the gasket on and then the diaphragm, not sure if that is correct or should it be reverse?

My engine did not start; then cleaned the carb and now it starts but then stops after 30 secs. During those 30 secs, it surges i.e. runs at high speed then slows down and then after a few spurts, it stops. Think it may be a governor problem?