Recent content by b1mmuo27

Thanks I looked through it 4 times but i didn't see a belt diagram for the mower deck. Am I blind? The second one has 3 pulleys mine has 5.

I am looking for a diagram showing the belt routing on a RC60-72 belly deck on my tractor. Its been a while since I replaced the belt & I'm stumped.

I have a 6 speed with a clutch B6200 tractor. It came with a 60RC-72H mid mowe deck. It's a front pto drive. I bought a 60RC-72H mid pto drive. That was a whoops. I now have to make this work. Has anyone else done this?

I have the above tractor with a 48 inch rear pto snow blower. It has turf tires on it. What kind of weight would keep the front on the ground? Thanks

Well if anything is good while isolating I get things done. My Kubota B6200D needed a new clutch so it got a new friction disc, pressure plate, throw out bearing. It never ran this good when I bought it. One thing I can't seem to figure out as an electrician is the mechanical tach works as...

Couldn't find anything but I finally got it set up correctly. Blades are now level.:)

Thanks I will look around.

Ok I'll post it tomorrow thanks

I have the above tractor & I am looking for the lawn cutting manual for it. It has the centre 60 inch under belly pto driven triple blade grass cutter. I have the owners manual & service manual for the tractor but neither have the grass cutter in it. Thanks

I just purchased a 2005 Murray Pro Series lawn tractor for parts for my Cub Cadet. The Murray has a 21HP B&S Intak engine in it & the cub cadet is a 19HP Intek. I plan on switching them as well as steering parts & the wheels. What I am looking for is the engine wiring diagram as I want to run...

I have used the blower twice now with the same thing happening. It starts blowing the snow fine then slowly the snow turns to slush & the blower just freezes up. I think I figured it out yesterday the the exhaust from the tractor is heating up the back of the blower slowly heating the snow to...

My tractor tires are 20 x 10. The chains that came with the blower attachment are for 20 x 8 or 20 x 10. When I try & put them on the appera to be way too small. Is it just me?

My lawn tractor takes a 190-032 or 190-823 snow blower attachment. Is the blower portion the same on the particular year MTD built tractors but the frame rail mounts specific? I ask this as I can get a new 42 inch cub cadet blower housing minus the mounting rails for my tractor. Thanks

Engine is a Briggs & Stratton Model 407.777 Type 0128 E1 Code 001 023YG. Any one know what year this engine is from? I am looking to replace the starter on it. After my Dodge Cummins wouldn't boost it I think the starter is screwed. I replaced the starter solenoid two weeks ago. But my 4...