Auto Doc's's latest activity

I consider this fortunate. I also recommend you get a can of seafoam or Chemtool B-12 pour in cleaner and put a couple of cap fulls in...

Are the blades all installed the same, or is one upside down? I've seen it happen before. Also, all of the blades should be identical...

https://www.partswarehouse.com/MTD-Kit-Service-Trans-MTD-753-06608-p/MTD-753-06608.htm?Click=765611&msclkid=b50b960e94c510d6158afe4470f87...

Disconnect the coil kill wire on each coil and see if the engine now runs on both cylinders. The engine can be shut down by the...

Honda got out of the mower business a couple of years ago and are now just depleting remaining stock. Here is a video with lots of...

Thanks, Srubcadet10 I've gotten so used to operator's manuals not having diagram information, that I did not think to check that...

I have this CC Z Force that has no power to the anti-backfire solenoid with key turned on. Solenoid tests good when powered manually...

Like StarTech said, these are already filled with a 00 grease and do not require any maintenance unless they break for some reason.

Check the input drive pulley. Likely it has hammered the center splines and is now loose on the shaft. It may need the shaft replaced...

Switch the wires on the two small terminals, may possibly work, if not, then switch them back. From what you described happening...

Look up Bohls Bearing in San Antonio TX, they can match anything you have if you provide a sample. I've used them for years to come up...

If it is what I think it is, that is a reverse implement cutout switch. That is there so the deck PTO shuts off whenever putting the...

Yea, this mower is around 25 years old, so stuff like this happens if they are still going all this time.

Check for a broken, loose or dirty ground in the harness. Often times a relay will function the opposite way if it is not getting a...

Just keep in mind that Voltage is potential and Amperage is power. A battery can read 12 Volts on a meter but still not have enough...