Recent content by allan01

First off- I want to thank you for the very quick reply. This was my first post. I wasn't sure of if or when I would get any suggestions to my problem. I never even thought that the issue might be in an incorrect or defective replacement switch. The Troy Bilt model is 14A7A3BA011 and it looks...

All of a sudden I'm not getting power distributed after ignition switch. New Battery and switch installed. So it's neither a battery or switch issue. Power to the switch confirmed with a meter. When key switch is off it shows full 12 plus volts but when key is turned to the on position no power...

Thank you all for responding. I was able to figure this one out and made the transfer. Good group, I'm sure I'll need yr help in the future.

The old Briggs is Model 217802 Type 0145 B1 code 0802147A and the new Briggs is Model 21R8070072G1 11.5 hp Type E1150.

Trying to add a gas tank from my older Briggs motor (Model 217802) onto a new Briggs E1150 engine that came without a fuel tank attached. Any help with how to mount the bracket that attaches to the tank from the old motor to the new one would be appreciated.

Trying to replace a Briggs model 217802 onto a Swisher 44 inch finish cut pull behind with a new Briggs 11.5 hp E1150 model and unsure what fuel tank to use since engine does not come with one. Also how to mount to the engine?