Recent content by ACF

engine has 135 hours, removed valve covers to verify tdc, got nothing from dip stick just muffler 135 hours and was tdc had valve covers removed watched springs

have a kawasaki fr691v-bs29 that smokes light gray/blue smoke looks like a smokestack while running. did compression test each cylinder was 130 psi. did leak down on both cylinders had air coming out muffler. so do i have bad rings and bad valve on discharge side. was thinking value guides...

reconnected the wires to coils tried to start and it started, did not have to clean carb used a little starting fluid and it started up and ran. so all you guys that have the experience what would you charge this guy for all the work that was performed again thank you for all of the help in...

rechecked and found the wires are connected to the correct terminal think that i need to get wiring harness for coils and it should start, once clean carb. thank you i have learned so much from this mower and with the help from you and this site,

disconnected switch reconnected had voltage but not constant when did have power the starter would engage only, owner reported that key switch was replaced wire 601a at engine connect checked out good continuity at c4m once it became a black wire there was no continuity, going to the wires at...

it's me again took star tech drawing # 2 sn 120001, did a continuity test on all the wires got a good long beep on all except for the ones going to the coils just got a beep then nothing, could d1 or d2 be bad, also the coils have jb weld on a post of each coil, but when i disconnect the ground...