2ball's latest activity

greasing all the Zerks seemed to get it to settle down. I guess I got the spindles to spin a little easier and lowered the inertia.

John Deere Multi-Purpose HD Lithium Complex Grease Grease-Gard™ Premium Plus Is there anything special about this grease? Can I use...

Dropped the deck again today. double checked it was the right belt, hand spun all of the pulleys. watched videos. everything seems...

I changed the broken belt on a JD X330. I don't think it matters, but the old blades were chipped, broken and they were dullest blades...

Hard to tell on the video, but I am cutting on a slope so big that I tried to sit on the fender to keep from sliding off the seat. When...

I have turned my push mowers on their side to get oil out and this never happens. This mower was fine after.

So I bought a new needle and float and installed them. I have not tested them to see if they are functioning property. I did cut grass...

I don't have a pump like that, but I blew on it with my mouth and it seemed ok!

I've been using the fuel shut off every time I put it away. I would then run it out of gas. The next start up I would use starter...

I took the carb off when I first got the engine. I cleaned it up best I could and mangled the main jet when I couldn't get it out.

My needle was bad, currently there is no tip on it. I ordered a new one. I hear the solenoid click. I put in a fuel shutoff and I have...

Ok, so a new needle, I probably need a bowel gasket, a new float wouldn't hurt and I can probably skip the seat for now? What Bowl...

I took the bowl off and this is what I found. The needle tip was breaking off and before I put it back together it broke off. It...

I might add. Some carb seats require a special tool to remove and insert without damaging the surrounding area. The tool is not...

From the issue you describe, sounds like your float needle is faulty, it can be fixed with Briggs repair parts 231855S and possibly a...