Laser Z SN 332739
Bought this used and only got a couple hrs on it.
Mower ran but wouldn't charge battery.
Tested the stator it was shorted.
Pulled motor found flywheel magnets were loose.
Epoxied magnets back on flywheel +-+-+- etc
Replaced stator.
Key on, fuel pump runs, solenoid clicks no start.
Jumped switch start to trigger wire on starter. Starter works, no power to coils.
Diagnostic only shows 61.
Coils do power up for the 1-2 secs when the fuel pump runs.
Control levers switch ignition on and off as expected.
Brake switch is working per the wiring diagram and does switch ignition on when closed.
24 pin plastic ECU case.
Pin 1, 2, 15 ok. As expected.
Pin 3 and 10 are open. I didn't expect that.
I don't know if I've got 1 or 2 problems could really use some troubleshooting assistance to get the ignition working, thank you
Bought this used and only got a couple hrs on it.
Mower ran but wouldn't charge battery.
Tested the stator it was shorted.
Pulled motor found flywheel magnets were loose.
Epoxied magnets back on flywheel +-+-+- etc
Replaced stator.
Key on, fuel pump runs, solenoid clicks no start.
Jumped switch start to trigger wire on starter. Starter works, no power to coils.
Diagnostic only shows 61.
Coils do power up for the 1-2 secs when the fuel pump runs.
Control levers switch ignition on and off as expected.
Brake switch is working per the wiring diagram and does switch ignition on when closed.
24 pin plastic ECU case.
Pin 1, 2, 15 ok. As expected.
Pin 3 and 10 are open. I didn't expect that.
I don't know if I've got 1 or 2 problems could really use some troubleshooting assistance to get the ignition working, thank you
Last edited: