tractornut3
Forum Newbie
- Joined
- Jun 12, 2013
- Threads
- 2
- Messages
- 9
When the mower gets hot the right side will not pull,butwhen it cools off it works fine.How can i fix it without replaceing it.
That is a sign that the hydraulic pump or motor is in the beginning stages of failure. Wear increases the clearances allowing the fluid to bypass the normal passages. When cold, the hydro oil is a little higher in viscosity and the mechanics are tight. As things build up to operating temp, the mechanics expand revealing the wear in the system.
Can you rebuild,if so where can i git the kit.
I have never even attempted to rebuild a timecutter's Xmisson. I have taken one apart, but couldn't see what went bad and why it didn't have full operation when hot. Are you sure the small release/bypass levers on each side are in the closed position? If they are not locked in place, the oil could be bypassing.