Search results

I have a zero turn not sure what model I need to purge the air from the hydrostatic pumps how do I properly do this..

I got cub Zforce zero turn 53aa5a6710...starts right up but when I release the brake or try to move it dies its got to be a safety switch but where do I start..

How would I go about purging the hydrostatic units on my zero turn .I do not have model number it was removed before I got it there is a unit for each wheel and a tank under the seat...hope this helps.

My 16 HP vanguard.. 303777..1111-a1.when it sit awhile will not start unless I spray gas in carb the it will run perfect all day long its just the cold start issue... Choke is working but has no effect when doing a cold start any ideas of what to check..

I picked up a craftsman gt5000 with a 22hp ELS model. 10h777..type. 0241 e1..code.030714yg..got it cheap and it runs and mows but it is smoking a bit so I put new head gaskets on it but didn't fix it I got 125 psi on one cylinder and 75psi on the other I am guessing it needs rings ..did I answer...

I got a husqavarna 42 inch cut zero turn with a 21hp Kawasaki that's blowing smoke so I want to put a 16hp v twin vanguard that's good to put on it..my question is will that be a big enough motor ..

I have husqavarna zero turn with a 21hp Kawasaki vtwin with bad rings I believe cause I replaced the head gaskets and vavle seals and it still smokes.. But I have a 16hp Briggs motor that is perfect how hard would it be to wire the Briggs motor up so that everything works I don't want to spend...