Recent content by dougw

I have noticed when cutting the deck does not appear to be level. Tried adjusting it but can not seem to get it right. Couple of questions. 1) how much different should the height be front to back? 2) how do you adjust the height on the front of the deck seems to be off at least 1/2" or more...

my rear engine rider is not cutting well the deck is pretty much level but the left side is cutting higher than the right side. This is leaving the yard looking pretty bad when i use it, any suggestions?

A friend on the north side of Indy has 2 mowers that quit running am pretty sure ignition modules failed I do not have room or time to do anything with them they are free for the asking. send me a message if anyone is interested and I will set up a time for you to get them. Doug

I am out of space and have a 1980 cast deck self propelled that needs a new home will start but needs carb worked on self propelled still works great. Includes side chute and catcher chute along with 2 bags may have original manual. Located on north side of Indianapolis free to good home Doug...

The recoil works fine problem is the gear only slides out about 1/2 way and if anything will just scrapes against the teeth on the fly wheel sometimes if you push it hard enough it will go all the way out and fully engage. If you take the recoil out it the gear pops all the way out no problem...

I have a 5237 that when cold starting have to keep pressing the primer for a while before it will keep running, after it catches it runs fine. Any suggestions? Doug