I tried unplugging the seat switch with the same results. I did find that unplugging the seat switch connector and spraying electronic cleaner in the plug works for 5 to 10min of use til mower dies and back where I started from.
The connector is staying plugged in on the switch locking onto the...
RZTL 54IN
17crcaca009
1d057h50187
When pulling the arms in it shuts off. When arms are apart that serves as the parking brake. When engine is running while in park blades wont come on either. I tried new seat switch and it didnt fix it. So I guess Im down to trace wires for a short in the...
Not
Not fuel delivery issue cause wont even start on carb cleaner. Flywheel was pulled and key was checked. Amazon carb. Doesnt matter where the carb is made its all made overseas now. I have amazon carb on pushmower I use here with no issues for 5 years.
Yes when looking up the camshaft and timing gear. The original timing gear was plastic but superceded to a metal timing gear and camshaft has plastic sleeve on the metal shaft.
126M05
6856-F1
12012756
Jan 2012
New carb, new head gasket, valves move freely up and down, flywheel key is good, 60 psi compression, has blade on it. Tries to start but doesnt.
https://www.dropbox.com/s/qzo8e2qu37zh50i/20230413_155102.mp4?dl=0
Sounds like from what your telling me its just easier to add the choke cable. Im not crazy on drilling hole in the dash on new mower that has 22.8 hours cause it would decrease the value of it. This engine would be using it temporary til found the right engine for the mower. I updated info on...
407777
0124 e5
010419yg
Im using this engine on mower doesnt have a equipped choke cable setup. The choke is built in on the throttle cable. How do I do this procedure?
Its going on a husqvarna yth24v54 original engine was a briggs 44r777. PO blew the engine within the first 22.8. This looks...
Echo 355t no start. Has spark and 120psi compression. Previous shop replaced carb with walbro carb and tried adjusting carb with no success. I ve tried adjusting carb(2 full turns out from snug on the H n L) as well with no success. Saw was owned by tree service. Does 355t have any known vaccum...
Update: Valves clearances are at .004
Never believe a spark tester on a champion plugs. Put new plugs in fired right up. idk how many times I flooded it when trying to start it after replacing the flywheel.