BWH
Well-Known Member
- Joined
- Mar 22, 2011
- Threads
- 31
- Messages
- 349
I have a new Toro 26” two stage snow blower which in the 1st 15 minutes of operation had the bolt that is tapped into the end of the crankshaft loosen up and fall out causing the wheel drive and blower drive to slip. I took it to the dealer he reinstalled the bolt and locktighted it, he said that he could see that the factory had lock tighted. Well about 15 minutes run time a week later it came out again so back to the dealer, he says he’s never seen anything like this.
Thoughts anyone?
Thoughts anyone?