Bobby Boyd
Active Member
- Joined
- Jan 10, 2012
- Threads
- 34
- Messages
- 99
I was greasing the rear zerk fittings and happen to notice my striping bar (roller bar) is not horizonal when in the up position. I don't see anything bent. Is there a way to level it? It was put on by the dealer.
Also when I greased the rear U-joint a glob of grease came out. Hard to see what one is doing. Is this what would be expected when greasing the U-joint? Not sure if I got my grease gun on the zerk correct.
Thanks again for your help.
-bobby
Also when I greased the rear U-joint a glob of grease came out. Hard to see what one is doing. Is this what would be expected when greasing the U-joint? Not sure if I got my grease gun on the zerk correct.
Thanks again for your help.
-bobby