You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
riding mower keeps shutting off when blades are engaged
- Thread starter semimechanicman
- Start date
More options
Export threadbertsmobile1
Lawn Royalty
- Joined
- Nov 29, 2014
- Threads
- 64
- Messages
- 24,705
make sure the governor is working
With the engine stopped to throttle butterfly should be wide open and close down as the engine speeds up
On a lot of the clone carbs the throttle butterfly can be hooked up so pulling can either open or close the throttle butterfly
Also make sure the governor spring is in the right holes
The governor always tries to CLOSE the throttle butterfly and it works against the governor spring which it attached to your throttle control so the engine speed is maintained as a tug-O-war between the governor & this spring
Different carbs often require different ( in your case stronger ) springs .
With the engine stopped to throttle butterfly should be wide open and close down as the engine speeds up
On a lot of the clone carbs the throttle butterfly can be hooked up so pulling can either open or close the throttle butterfly
Also make sure the governor spring is in the right holes
The governor always tries to CLOSE the throttle butterfly and it works against the governor spring which it attached to your throttle control so the engine speed is maintained as a tug-O-war between the governor & this spring
Different carbs often require different ( in your case stronger ) springs .
28_RER_Tom
Forum Newbie
- Joined
- Feb 24, 2020
- Threads
- 0
- Messages
- 1
Did you happen to remove any wiring? Almost sounds like the seat switch is disconnected.