Export thread

I have a grasshopper 725 front deck mower and need to load it on a trailer. my question is how or what has to be done to make it possible to push or pull it. I have finally faced the fact that it's going to take someone other than myself to find out why there's no spark. all help is greatly appreciated.:confused2:

There is a dump valve under each hydro. Use a 5/8 wrench to turn counter clockwise one revolution. This will allow each side to freewheel. Just don't forget to tighten them back up!

mlh727 said:

There is a dump valve under each hydro. Use a 5/8 wrench to turn counter clockwise one revolution. This will allow each side to freewheel. Just don't forget to tighten them back up!

Click to expand...

would that be a brass colored bolt head with a hole thru it cross ways? maybe an 1/8" hole?

I don't remember if its brass or not, but its at the bottom. Just turn it one turn and it should release the wheels. Don't take it out, just loosen it.

mlh727 said:

I don't remember if its brass or not, but its at the bottom. Just turn it one turn and it should release the wheels. Don't take it out, just loosen it.

Click to expand...

thanks alot. same way a dixie chopper release's

gary sr said:

thanks alot. same way a dixie chopper release's

Click to expand...

thanks alot mlh 727 . that done the trick