I have a yard machine, 18.5 B&S. quit last year. Its around a 99 model (when I say quit, it was a starting issue not a motor)Today I changed the oil, gas, plugs, drive belt, new battery, and ignition switch. went to turn the key and nothing. I discovered my tranny will not go into neutral. I had removed the bracket that holds the shifter lever to install the belt, and now it is not going into neutral. I think this might be the problem, at least not cranking over, but not sure. wheels do spin opposite when jacked up.
NOTE- before removing the shifter bracket I did try to remove the rear pully attached to the transmission but no luck, is this where I screwed up? it was in neutral earlier today because I let it roll off the trailer.
Model is 13AS679G062
I also put on new solenoid and checked the fuse next to it. I only found one fuse
NOTE- before removing the shifter bracket I did try to remove the rear pully attached to the transmission but no luck, is this where I screwed up? it was in neutral earlier today because I let it roll off the trailer.
Model is 13AS679G062
I also put on new solenoid and checked the fuse next to it. I only found one fuse
Last edited: