Deck is off and mower sitting up on planks and saw horses. Just installed a new carburetor and put the old cracked " Drive" belt on until new one arrives. It fires up fine but dies when clutch/brake is released. Drive belt is in correct configuration.
It was running too rich and would start smoking black and want to die before the new carb but didn't. Now with a minimal load it is dying out. Does the carb need an adjustment; if so- where can I find the specs?
Thank you- Phil
It was running too rich and would start smoking black and want to die before the new carb but didn't. Now with a minimal load it is dying out. Does the carb need an adjustment; if so- where can I find the specs?
Thank you- Phil