Search results

Everything feels good and tight, don't feel any unusual wear. Put a new primary belt on, variator has been adjusted several times. Curious on the "forward postion of transaxle." Can it be moved forward? Don't know if that would help with my problem. Also curious on the clutch override and brake...

am working on an old 112 that will just grind the gear when trying to shift in from neutral. I have pulled off the belts, did not replace as they look fine, and made sure the variator was moving freely and put some lube on the center shaft to make sure it continues to slide. I have adjusted the...

I just cant stop the wheels from spinning in neutral. I have tried adjust the concentric bolt and adjusted the control arm, but every time I step on the brake to stop and then release it, it starts to creep again. All the linkages are tight and I do not see any wear. It is the style where the...

My next project is the 318 and the starter (brand new) is kicking out, but it just hits the flywheel. Unless the teeth happen to line up, then it kicks out and fires right up. I feel like the Bendix should be kicking out and spinning just enough to catch the ring gear. All the teeth look fine...

I have this tractor that suddenly lost spark. Full spec of the engine is FB460V-AS26. I have replaced the ignitor, not with the oem as it is very expensive and figured (hoped) they are all pretty much the same, spark plug, and spark plug cap. I still have no spark. I have disconnected the small...

This is a strange one to me. I am only running on one cylinder. The dead cylinder has spark, as verified by 2 new spark plugs grounded against the engine, in line spark test, and spark gap test (jumping the gap from 3/8" to 1/2".) I have unplugged the kill wires from both coils with no change...

I am working on a White GT2055 with a hydraulic lift system. The deck will not raise or lower. I believe the valve is the issue. I have put new seals in it and took it apart a couple times. With the valve closed, in neutral position, I will get fluid out of the return port and both work ports...

I just did some repairs to the transmission, replaced the main input gear and bearings. I reinstalled with a new belt (1/2" X 89") now the mower runs forward and reverse as it should, so I am confident in that repair, but when I push in the clutch it continues to move. Looking under the mower...

I know, another one of these threads. Seen a lot of info but never seen anyone post their resolution. As the title suggest the recoil is snapping back when trying to start it. Once running it runs perfect. The engine was rebuilt last year, and I am assuming the cam timing was put back in...

I have a Cub Cadet with a Kohler CH18 engine. Sometimes I can hear the solenoid clicking but the engine wont turn over. If I hit the key 4 or 5 times it will come to life, starts and runs fine. I have a fresh battery, shows 12.8V at the B+ post on the solenoid, when I hit the key I am showing...

Hi guys, I have an Onan P220 that surges at full throttle, as the title says. It idles perfectly and even runs fine wide open with the pto engaged. I am working on it for someone and they just don't like the surge and want it gone. Carbs are expensive for this one and I would want it narrowed...

Hi all, I am working on this mower and have no idea what is going on with it. I see lots of posts on this problem but everyone's solution doesn't seem to help me out. Mower ran out of gas, came back and filled it up and it now wont start. What I have done: cleaned carb more times than I want to...