Search results

Two part question......how many safety switches does it have and where are they located....and how do I test each one to see if they are bad

I have a zero turn john deere with a briggs 23 hp engine and just had the carb rebuild at shop....carb runs fine if you spray a bit of starting fluid to help it get started.......after sitting a while it will not start without the starting fluid again then runs fine. Anyone know what the problem...

Ok, guys need some help here....this thing has me stumped....this is the problem: crank it up, runs fine, pull in forward move handles it goes dead. so I bypassed both of them for a bit to see if that helped and it did the engine would stay running and it would move around......try to turn on...

fuel pump is pushing gas all the way to the carburetor inlet but engine will not start.....fuel pump just replaced and pumping .if I slowly pour gas slowly into carb it will start and run as long as gas is poured in it and when I stop the engine will run for a second then die......what can I do...

Getting fuel all the way up to the carb but engine won't run unless gas is gently poured into carb and when you stop pouring it goes dead....what might be the solution.....I can pull the carb off if it needs to be....is there some things I might try at home to get it going before taking it for...

When engine start.......starter wheel will not disengage the flywheel.....what could be the problem