Search results

The My CMM1200 battery-operated mower has a 24V charger with a 3-pronged plug but the charger is dead. I kept the two 12V batteries charged over the winter by removing them and individually charging with a 12V maintainer charger (as used for motorcycles). I now found another 24V charger for a...

I have an old Toro mower with the Suzuki "VMG6-126374" engine. Could someone tell me how many horse power this engine is, please?

I acquired a Mastercraft 137D673G515 garden tractor (made by MTD) that needs repair. It was sold by Canadian Tire in Canada and the MTD data base won't accept the serial number in order for me to download a manual for it. Does anyone have a valid MTD serial number I could use? Also, it needs a...

Thanks you, Mechanic Mark. You have led me to the problem. See the photo below: The motor, shaft and blade were OK, but the blade had moved over sideways. I will need to replace the plastic fan assembly above the blade because it centers the blade and has worn down to allow the blade to...

I have acquired a Yardworks electric mower (model 18A-V17-515) with a German "Robert Stahlschmidt" motor. It appears to be an AC motor because the 2-wire power cord goes directly from the handle switch to the motor and NOT through a bridge rectifier. It also has an 80 MFD, 240 Volt capacitor...

I'm trying to disassemble an old electric motor off a Sears lawnmower Model C950-35100-2. I believe all the bolts holding the two halves of the motor/gear casing have been removed. There is still something preventing me from splitting the two halves. Below is a picture of the motor, sitting...

Hi everyone, I'm a multi-mower owner because I repair and resell old mowers... usually about 30 a year. Once in a while I run into a problem I can't solve and therefore will post my situation, hoping to get another member's solution. Happy mowing.

I have several Black & Decker corded mowers, all 120V, 12A, 18". I had to replace brushes on one, so I decided to remove the magnet shell in order to give the motor a good cleaning. After re-assembly the armature would not spin freely. I double checked ALL places where it could bind or rub on...