Search results

I have a 2003 27 hp, 60 inch cut bad boy mower. when i go to the right its ok but going to the left it seems like there's a brake partially on on a blockage somewhere in the hydro part of it. you can feel a slight vibe or jerking feeling, not real pronounced but very light feel of one. anyone...

I have a 2004 hopper 725 g2 w/ 3 cyl. gas kubota engine. It lost spark at the plugs and now I'am trying to pinpoint the culprit. tried to bypass the switches with a jumper wire on the seat switch, the parking brake also used two wires but not really sure on the correct way to jump those, the...

I have a grasshopper 725 front deck mower and need to load it on a trailer. my question is how or what has to be done to make it possible to push or pull it. I have finally faced the fact that it's going to take someone other than myself to find out why there's no spark. all help is greatly...

2003 gas 3 cylinder wg-752. putting new pickup coil or module on mower but not certain of gap needed.Usually on auto's I leave just enough room to clear the other parts. thanks everyone

:confused2:2003 kubota 3 cylinder gas engine. how do you remove the factory installed distributor from the block?. has no bolt where you adjust timing, just a metal cap or cover. please help, hammer is too close for comfort.

WE are trying so hard to get this grasshopper going, every time one thing is repaired or corrected up blooms another. not always big or bad problems but test your temper type issues." its all good though ". were working on a 2003 kubota 3 cylinder gas powered engine and we cannot figure out why...

I have a grasshopper 725g2 with a gas 3 cyl kubota engine which has 135 psi compression on all 3 cylinders the carb has been cleaned and doesn't seem to be blocked anywhere. I can place my hand over the carb opening while cranking and still not get any fuel. thanks for reading and thanks to any...

why or what causes fuel to go into the crankcase when not in use?