I am doing the drive belt replacment too (on a JD 160)> Could I somehow get that JD info too? Ron J Thar steering involvement has me puzzled. If you could send m thar JD Service tech manual PDF I would really appreciate it Even just the part involving replace ment of drive belt..really like...
I broke the small wire on coil right at the plastic insulation so have no stub to solder a wire on. Replacing coil is confusing because some of these systems have been replaced with a solid state system. I would like to replace coil only. Anyone have part number for original to replace coil...
I have f525 with bad rod and crank, can i pull the engine block without removing the whole Kawasaki unitized power system from the chassis? Can I leave the tranny part in the chassis, and lift out engine section with block and crank? Ron
I ohms tested coil: OK. Anyone know of igniter test? Should I have spark with primary coil wire off. I know this wire intende to ground out primary side to stop engine but it also goes to igniter. No spark with primary wire off. Do I need connection to igniter to have spark?