Recent content by Pochie

Yes! I see the 'wings' are now where they attach to the frame and the ad pictures didn't present the shield correctly. I think mine is bent up and that is why it sets too high and hits the hood when opening. At least now I can order a new one when mine finally falls off again. Thanks so much...

Wow! How embarrassing! My mower # is YTH8542. I never thought I was dyslexic but I do find myself now at 73 reversing some numbers...I always check many times but this was 5 years ago! Oh well, Thanks for bringing it to my attention. I looked at your diagram and online manual and 532439870...

My mistake...I purchased in 2018. Is there a different shield # for the 2018 model then? I'll have to locate my manual. May have copied incorrect data. Will get back soon. Thanks.

My 2018 Husky has performed very well since purchasing it new. Model: 960450059. In April of this year I noticed my exhaust front shield was hanging down on the left side. I put a new bolt/washer/lock nut on. Yesterday (Sept. 28th) I noticed the bolt and hardware had fallen out and it was...

Just getting on forum due to health. Will read info you sent..thanks@

MT23..trying to raise front of deck 2" higher than rear..also now same pin height as front. for leaf collection..pulled pins out..deck doesn't move...deck in 2nd pins from top as was when purchased in 2013.

Kohler engine...Walker Mower MT23GHS...Tractor SN: 122738...Engine Model#: CH23-CH680

2013 Mower purchased new. The gearbox oil fill/check tube for the PTO I understand, have drained and replaced at 100 hours. The deck drive gearboxes I check yearly and understand. In greasing today, after many times I saw a label on the machine under(near) the battery area. There is a Allen...

I found 2 what looked like sensor hookups...disconnected...wiped with cloth...now the Oil Pressure Light comes on and alarm sounds! Will keep looking to see if I can locate Overheat Light. Will buy some anti-ox compound. Thanks again!

I will do this. I have found a few connectors and will try what you suggest. I hope to look at my manual today. Thanks!

Have the mower on my lift...looked at every wire and harness I could find...no red lights. Headlights work as always. Tested swivel grass spreader in dump cart as this is a grass handler system...you turn to first notch on ignition and engage PTO lever and spreader swivels as new...but alarm...

Good idea. I haven't taken it off yet. I took the bulbs out and they tested good. Kept trickle charger on. Sometimes when starting to first notch...the one red light would come on and alarm sounds..then the next time..nothing..the mower started up as normal...I took battery out and cleaned...

I checked oil 3 different times after running....FULL at mark. Oil only has 3 hours on after last oil/filer change last November after last mow. Will take blower top off and air pressure. WIll get back.

First time this happened since new. Started the other day from winter storage. Gas added and started right up. Let run 10 minutes and shut off. Later when starting noticed no oil pressure red light and overheating red light (2) on and no alarm sound as was usual. Turned on and off 3x and no red...

Hello. I wanted to update you. I received my new fuel pump and it still didn't start. I took the air intake hose off and shot some starter fluid in and she started right up! I let her idle for 10 minutes and then mowed re 20 minutes. Then I stopped and started her 2x and she worked like new. Do...