Recent content by LT1045wrh

Hi Everyone I have a 420cc Irontron engine that was running fine. I turned it off then tried to start it up again but no spark. I disconnected the oil sensor and shut off switch and tried a new spark plug but still nothing. can’t find much on this engine so I was hoping someone here might have...

Great thank you. The shaft is solid and the pulley wobbles. I can actually see space between shaft and pulley as I move it. Also thank you for the part number.

Hi All Got an old 2004 Murray Select model 425001x8B Was working on it today and noticed it has a very wobbly drive pulley on top of the transmission. think it’s just the key or is the pulley worn out? TY

😳 Just torqued mine down to 80 ft lbs since I couldn’t find torque specs in the manual. Used the torque from other mowers I have. wow if I loosen them up to they might fall apart!

Thank you. I spent the day on YouTube. I agree it is probably that strap that broke.

My RZT 50 did the same thing. I found it had a corroded fuse. Put another inline fuse holder and fuse on it and runs great.

I have a 2008 LT1045 w/483hrs. Kohler Courage 19HP Model: SV600 Ser: 3733206553 Just gave it an oil change and all was good. Started it this morning and heard an odd clunk sound. when I lowered the throttle the clunk went away. Increased throttle and clunking would continue. Drove it around...

Is the valve cover directly over the muffler? Mine smokes after sitting a while due to the oil dripping out of the valve cover seal and oiling up the muffler.

Checked pto w/o belt and pto spins. Checked belt tension and it was very loose. I shortened one of the idler pulley springs and all works good. Thank you for your suggestions.

CC LT1045, 2008. After an hour of heavy mowing I bumped the PTO button and shut off the blades. I tried to pull the PTO button back on but the blades just spin at a low speed despite running at full throttle. I let the mower cool down and the next day tried it again. Same result, blades only...

Hi, The bolt that holds the lap bar in place fell out. What is the procedure to install a new bolt? 2008 CC RZT50 Please help can't find any info on the Internet so far. Thank you

Hi Everyone, Just completed a fluid change on the hydrostatic transmission on my older model RZT 50. I never did this, so thought it was about time to do so. It was pretty simple so I thought I'd post some pics of what I did. I took info from several of the posts here and videos elsewhere to...

Hi, My 2007 RZT has been, and still is, a great machine. I've run it hard and mow about 8 acres of Central FL grass, basically all year long. Just want to share my electrical issue with you all. Maybe it will help some of you folks... One day I went to the barn to start my mower and got...

Hi Everyone, I haven't had this problem in the past, but when I was mowing the other day, the grass cuts fine but when I reach a thick patch (not anything the mower can't handle), the blades seem to slow way down. This has never happened before. I can hear the blades. Odd, but I know my mower...