Recent content by keyser318

So I took out the unloaded and it only travels 1/16 to 1/8 of an inch. Should it travel more? It also appears the piston is bent. We I turn the piston it moves non concentrically

Hello everyone I have a generac power washer RMV 3440. I started with two problems. Constant leaking of water and low to no pressure. The constant leaking water has been stopped by replacing the bushings in the pump part #27 from diagrams and one clearly damaged 42123 valve. So the water has...

so the end of the pistons look fine. Should I take apart the pump to inspect the parts of the pistons I can’t see?

NeverMind I realized it is a valve!

the plastic piece looks to be damaged, but I am not sure what it is. Does anyone know what to call it?

Awesome. Thank you. I am a little new at this. So do I need to drain engine oil when I take the pump apart or is the oil for the pump separate? also, if the piston is damaged where do I find the part number for it? I tried googling 2234 from the picture, but nothing comes up. Am I reading...

What do you think it is?

Hello, I have a pressure washer that is leaking like the attached pictures. I am thinking maybe the o rings have failed as it struggles to maintain and build sufficient pressure. Two questions: 1) does this sound like a correct diagnosis? 2) when replacing the o rings will oil come out there...

Hello every one I have a ryobi back pack blower RY08570. I have replaced the spark plug, replaced the gas with a premixed 50:1 fuel to oil ratio, cleaned the carburetor, removed the muffler and spark arrestor. It does not appear that the exhaust port is dirty or obstructed nor did it appear as...

Hello every one I have a ryobi back pack blower RY08570. I have replaced the spark plug, replaced the gas with a premixed 50:1 fuel to oil ratio, cleaned the carburetor, removed the muffler and spark arrestor. It does not appear that the exhaust port is dirty or obstructed nor did it appear as...