Recent content by Andysp

Hi wonder if any one can help where could I get one of these float needles or tell me the model of carb?

Thanks for the reply.There is a number there 131 H.Still can't get a exact match online.

Hi,I have one of these and was looking for a replacement carburetor it is hard to start but runs well when started.It has a Zama 13 carb.I looked up ebay to find a replacement but can't seem to get the exact one.Any advice would be great.

Hi,does anyone use one of these to tune there chainsaw?I bought one and can set the idle but when I try the high revs the screen just goes blank/turns off.Any idea what may be wrong?I have set it for the one cylinder setting

Hi,I have got a pole saw with an identical looking engine to this one but there are no labels or markings on it.Did some reading up on the net and this engine is fitted to a lot of those 5 and 1 tools.I'm trying to get the correct oil/petrol mix and I have read anything from 25/1 to 50/1.Does...

Hi I have a rover lawnmower with this engine.After priming it starts first pull but then dies out.If I keep giving the primer bulb a few presses while its dieing out it will keep going and after a few minutes it will run without help.To restart I have to prime again but it will keep running.I...

The Honda number is wx10k1a.Here are a few pics.

Hi I wonder if anyone can help with this small 4 stroke engine.It starts with two or three pulls but only runs for 2 minutes and stops.I cleaned the tank and fuel filter no change.Dismantled the carb and cleaned it no change then bought a repair kit for carb but the problem is still the same,any...