I have a tecumseh tvs90 with 3.8 hp.
Model # 46055B (c).
It is used on a mtd-yard man leaf vacuum.
My question concerns the wiring harness for this engine.
I do not know where all the wires were attached and haven't seen a video or pictures.
There is one wire (green) still attached to the ignition coil and i believe the other end attaches to the throttle plate assembly.
Could i piggy tail of this wire and run the other end of this wire to a switch and then add another wire to use as a ground?
Any help would be much appreciated
.
Also, wonder if i could just rehook the green wire from coil back to throttle plate and use the mechanism on the throttle plate to turn engine and off?
Model # 46055B (c).
It is used on a mtd-yard man leaf vacuum.
My question concerns the wiring harness for this engine.
I do not know where all the wires were attached and haven't seen a video or pictures.
There is one wire (green) still attached to the ignition coil and i believe the other end attaches to the throttle plate assembly.
Could i piggy tail of this wire and run the other end of this wire to a switch and then add another wire to use as a ground?
Any help would be much appreciated
.
Also, wonder if i could just rehook the green wire from coil back to throttle plate and use the mechanism on the throttle plate to turn engine and off?
Last edited: