tomswoodwork1
Forum Newbie
- Joined
- Jun 5, 2019
- Threads
- 2
- Messages
- 3
I have a 2004 Lazer Z with 52" deck. I replaced the spindle housings 2 years ago with exmark 103-2533 spindles. The jack shaft assembly was also replaced. I thought that I set to go.
Today I heard some noise around the outer spindle below my left foot. After removing the deck and belts, I saw that all of the pulleys were tight when I rocked them and spun them. But I then noticed that they were easy to pull up and down. Approximately 1/2 to 3/4 inch.
That wasn't just one spindle assembly, but all three blade spindles and the one on the jackshaft.
What in the heck happened? It has me lost.
Today I heard some noise around the outer spindle below my left foot. After removing the deck and belts, I saw that all of the pulleys were tight when I rocked them and spun them. But I then noticed that they were easy to pull up and down. Approximately 1/2 to 3/4 inch.
That wasn't just one spindle assembly, but all three blade spindles and the one on the jackshaft.
What in the heck happened? It has me lost.