Hello, I wanted to start with please forgive my ignorance. I am not mechanical at all with engines, or machines like this. This is my first time attempting to tackle this type of issue, so if I use the wrong verbage I apologize.
A couple months ago I ran into an issue with this lawn mower where the belts finally gave out. The lawn mower choke could not be pulled. I did lots of research, replaced the flywheel key(I first thought this was the issue), and finally replaced both the front and rear belts, once I looked closer and saw they were overlapping each other and fraying. The lawn mower finally starts up, but the self propelled is instantly engaged at fully speed. I have tried adjust the cables near the handle, but the result is exactly the same. I feel like when I put the new belts on they are pulling the self propelled system tightly.
If anyone has any incite I would appreciate it.
Thank you,
Biscuit
A couple months ago I ran into an issue with this lawn mower where the belts finally gave out. The lawn mower choke could not be pulled. I did lots of research, replaced the flywheel key(I first thought this was the issue), and finally replaced both the front and rear belts, once I looked closer and saw they were overlapping each other and fraying. The lawn mower finally starts up, but the self propelled is instantly engaged at fully speed. I have tried adjust the cables near the handle, but the result is exactly the same. I feel like when I put the new belts on they are pulling the self propelled system tightly.
If anyone has any incite I would appreciate it.
Thank you,
Biscuit