My Craftsman mower is rear wheel drive and has a Honda engine. It's about 6 or so years old. There are two metal gears that are supposed to mesh together to drive the wheels. One is a larger gear attached to the wheel hub. The other is a smaller one that is attached to the drive axle. The drive gear spins but is not engaging the wheel gear. The rear wheels are fairly new.
Again, these are both metal gears. This is not the typical problem people have where the metal drive gear wears out the plastic teeth that line the inner wheel rim. Mine doesn't have that type of system.
Does anyone know how I can get these two gears to engage?
Again, these are both metal gears. This is not the typical problem people have where the metal drive gear wears out the plastic teeth that line the inner wheel rim. Mine doesn't have that type of system.
Does anyone know how I can get these two gears to engage?