Hey guys! New to the forum! I had someone bring me a husqvarna with a Kohler motor KT745 3011 26hp to work on and he said it was flooding and gas was getting into muffler. My first thought was carb needle but as I was doing tests on ignition I got zero spark on either coil. I believe this is an MDI coil 32 584 07. I disconnected kill wire from coils and still no spark. Resistance from ignition lead to armature reads 7.14 on one and 7.40 on the other. From ignition lead to kill terminal reads 17.14 one one and 17.46 on the other. Am I missing something or did both of these coils go bad at the same time? I also read you're suppose to connect the side not being tested to ground or installed plug which I did not do until I read it in service manual. Thanks guys!! And this part number also is showing 32 584 07 has been changed to 32 584 24s. If anyone can verify that for me I would greatly appreciate it!