When i push the lever to start my blades turning...

Fatdaddy

Fatdaddy

Well-Known Member
Joined
Jun 5, 2012
Threads
40
Messages
147
ZD327

I get it up to the position but the blades will not turn.. I keep giggling moving the lever it some times will start the blades..
hit a big bump and it will dis engage.. I keep adjusting moving it will start..
WHAT might that be to fix it.
 
M

MrGraff

Forum Newbie
Joined
May 6, 2020
Threads
1
Messages
6
Sounds like either the wet clutches are out of adjustment or low on fluid. Take it to a dealer and have them diagnose/fix it for ya.
 
K

keakar

Well-Known Member
Joined
Apr 28, 2020
Threads
15
Messages
277
Fatdaddy said:
ZD327

I get it up to the position but the blades will not turn.. I keep giggling moving the lever it some times will start the blades..
hit a big bump and it will dis engage.. I keep adjusting moving it will start..
WHAT might that be to fix it.
Click to expand...
those PTO switches have a lot of amps running through them

could be a bad wire moving around when you hit bumps, look for chaffed wires or loose connections, but if you have to wiggle the switch for it to start working again then its most likely the switch is bad, the switches are not expensive to replace
 
Hammermechanicman

Hammermechanicman

Lawn Addict
Joined
Jan 10, 2020
Threads
52
Messages
3,512
What is make and model of mower. Electric clutch or belt with moving pulley to engage the blades?
 
L

lugbolt

Well-Known Member
Joined
Sep 26, 2019
Threads
3
Messages
130
what is it? ZD326 or ZG327? I don't recall a ZD327??
 
You must log in or register to reply here.

Footer Links 1

Top