...and got it.
No Spark to Tecumseh Tiller Engine!
- Thread starter Golodkin
- Start date
...and got it.
sgkent
Lawn Addict
- Joined
- Sep 27, 2017
- Threads
- 30
- Messages
- 1,679
i am late to this party. Glad it is running again. 
When in a forum and asking for help I always put my city and state in just in case someone might be a neighbor who knows the device in question.
Super job and sticking with it.
When in a forum and asking for help I always put my city and state in just in case someone might be a neighbor who knows the device in question. Super job and sticking with it.
dustrtin1975
Member
- Joined
- Jun 6, 2019
- Threads
- 3
- Messages
- 15
near Cincinnati Ohio here/ ,, I seem to have the same issue on the same model engine I think this is mine hh60 105106f ser.9088c mine ran pretty good but at full throttle it just sounded like the engine was floating for lack of a better word, so only thing I did was change and set points, from that point on NO SPARK, even had a shop look at it, my question is , where can I locate procedure on how to set the gap for the coil to magneto ?
- Joined
- Sep 24, 2017
- Threads
- 250
- Messages
- 6,437
Setting the air gap is fairly easy, loosen the coil mounting bolts, get a index card and place in between the coil and flywheel, press the coil against the index card and tighten the 2 screws back up.