Hello all,
I bought a new Troy Bilt Storm 2860 late last spring and used it a couple of times. I use ethanol free gas and treat it. I left the fuel in it since it was treated (bad move). Yesterday I tried to start it and no go. I finally got the shroud off and got some starting fluid into the carb and it started right up and ran for a few seconds. The tube to the primer bulbs is OK, so no air leaks there.
How much of a job it it to get the carb off and clean it?
Does anyone know where you can find a manual on the engine etc?
Thanks in advance.
Dave
I bought a new Troy Bilt Storm 2860 late last spring and used it a couple of times. I use ethanol free gas and treat it. I left the fuel in it since it was treated (bad move). Yesterday I tried to start it and no go. I finally got the shroud off and got some starting fluid into the carb and it started right up and ran for a few seconds. The tube to the primer bulbs is OK, so no air leaks there.
How much of a job it it to get the carb off and clean it?
Does anyone know where you can find a manual on the engine etc?
Thanks in advance.
Dave