tj4ndirish
Forum Newbie
- Joined
- May 13, 2016
- Threads
- 4
- Messages
- 4
Hi all......
Was mowing today and the blades stopped turning. Checked underneath and found a sliver rim broke and bent. Further investigation is that is was part of the pulley from the clutch. Based on what little information I can find, the whole clutch needs replaced. But, here's my problem, I can't get the whole clutch out. Got the lower part out, but the "bell housing" is still on the shaft. I've given it a couple of encouragement whacks and nothing. I've soaked it in WD40 and nothing. Can anyone give me suggestions on how to get the upper half out with out destroying the shaft?
TIA
Was mowing today and the blades stopped turning. Checked underneath and found a sliver rim broke and bent. Further investigation is that is was part of the pulley from the clutch. Based on what little information I can find, the whole clutch needs replaced. But, here's my problem, I can't get the whole clutch out. Got the lower part out, but the "bell housing" is still on the shaft. I've given it a couple of encouragement whacks and nothing. I've soaked it in WD40 and nothing. Can anyone give me suggestions on how to get the upper half out with out destroying the shaft?
TIA