Powerstar XP-620

S

Steve_trucker

Forum Newbie
Joined
Feb 21, 2016
Threads
1
Messages
4
Hi there I believe my ride-on is an old whitefied the engine did a piston ring and the best option was buy a bolt on replacement. I've it all going just about but every time I run power to coil it blows the fuse. Can anybody help out in how it to get firing away... Help!!!!
 
BlazNT

BlazNT

Lawn Pro
Joined
Apr 26, 2012
Threads
28
Messages
6,973
Normally 2 things cause this.
1 fuse is too small. What is fuse rated for?
2 Power wire is grounding out. Check all wires for freed ends that could be touching ground.
 
S

Steve_trucker

Forum Newbie
Joined
Feb 21, 2016
Threads
1
Messages
4
Ok sweet. Where or how should I get power to coil? I think I might of butt the coil not sure yet.
 
I

ILENGINE

Lawn Pro
Joined
May 6, 2010
Threads
39
Messages
9,929
Steve, it might help us to know what brand and model of engine you are trying to hook up. By blowing the fuse, you either have a short, or trying to hook up power to something that doesn't need power.
 
S

Steve_trucker

Forum Newbie
Joined
Feb 21, 2016
Threads
1
Messages
4
Yeah sorry it's a Zongshen power star XP620. I'll see if I can post a picture of the mower thanks for all your help
 
BlazNT

BlazNT

Lawn Pro
Joined
Apr 26, 2012
Threads
28
Messages
6,973
Manual.
[URL="http://www.zongshenpower.com/index/show/15/98.html"[/URL]
I will find a generic wiring diagram in a few.
 
B

bertsmobile1

Lawn Royalty
Joined
Nov 29, 2014
Threads
64
Messages
24,702
Steve_trucker said:
Ok found that I fried the ignition coil somehow
Click to expand...

Usually this is because you put 12V accidentially into the earth cut out wire.
Very easy to do.
The thin black wire must either be connected to earth ( turned off ) or open ( turned on )
Good luck trying to get a replacement .
 
You must log in or register to reply here.

Footer Links 1

Top