You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
Craftsman tractor DLT 3000 won't move
- Thread starter ghash23
- Start date
More options
Export threadbertsmobile1
Lawn Royalty
- Joined
- Nov 29, 2014
- Threads
- 64
- Messages
- 24,700
There are 2 belts.
The transmission belt is tucked up high where it is hard to see and harder to get sticks & stones to.
You really have to pull off the deck, get uder the mower, put the brake on ( makes the drive belt slack ) .
Mark the belt with a white marker then run it completely around and check for missing lumps.
You will find it a lot easier is you drain the fuel tank , sling the engine by the front axels and stand it vertical.
While it is up check all of the little pulleys, the action of the clutch/brake
The transmission belt is tucked up high where it is hard to see and harder to get sticks & stones to.
You really have to pull off the deck, get uder the mower, put the brake on ( makes the drive belt slack ) .
Mark the belt with a white marker then run it completely around and check for missing lumps.
You will find it a lot easier is you drain the fuel tank , sling the engine by the front axels and stand it vertical.
While it is up check all of the little pulleys, the action of the clutch/brake
mechanic mark
Lawn Pro
- Joined
- Jul 15, 2013
- Threads
- 175
- Messages
- 7,407
Post model number from under seat as well as year. Make sure rod at backside of tractor is pushed in all the way. Check your drive belt for replacement after removing deck. I would also remove idler pulleys & inspect bearings by hand for dragging or being locked up.