Search results

Results 1 to 13 of 13
  1. S

    Briggs 22hp Surging Badly

    It was in the carburetor...... It's fixed for the time being. Fingers crossed. Thanks
  2. S

    22hp Briggs Carb Problem

    Problem solved.........Thanks
  3. S

    You wrote in a thread about this 22hp briggs surging.... The govenor is bouncing because the low...

    You wrote in a thread about this 22hp briggs surging.... The govenor is bouncing because the low speed metering circuit in the carb is not working correctly. Can you elaborate a bit on that?
  4. S

    Briggs 22hp Surging Badly

    This is not the carb I'm working on but is a close representation. Does anyone know what the function is of these 2 ports?
  5. S

    Briggs 22hp Surging Badly

    I must have a non-normal carburetor or I'm not pushing hard enough on it. The jet feels like it seats in the plastic tower but when you tune it over instead of the jet being all the way at the bottom it actual sits about 1/2 inch below the bottom of the plastic piece. When I run a drill bit...
  6. S

    Briggs 22hp Surging Badly

    I was told by a briggs guy here in town there were no orifices to clean and nothing to gain by removing the intake manifold from the carb. True or not? The only piece I did not change in the carb was the plastic piece that hold the main jet. How far does the main jet fit into the plastic...
  7. S

    Briggs 22hp Surging Badly

    I have never taken the intake manifold off the carburetor. The "plastic" seals on the intake manifold to the head look good. The carburetor to bowl gasket was replaced with B&S part. The float level I will have to check, but I belive it is sitting in the correct position. Is there an idle...
  8. S

    Briggs 22hp Surging Badly

    On going Surging issue. I have a 44N677-0005-G1 with a 594207 carburetor. It belongs to friend of mine. It had an issue a few weeks ago with the solenoid not work and not allowing the engine to start. Once it was freed it ran great. Fast forward 2 weeks and running it to mow about 2 acres he...
  9. S

    22hp Briggs Carb Problem

    Is there something I should be looking for when I tear the carburetor down again?
  10. S

    22hp Briggs Carb Problem

    This thing is driving me batty. I will now run with the main jet in place but now surges and all speeds. If the the lever is pushed up to choke it just a bit it smooths out. It ran like a champ before with no surging but was flooding the cylinders with gas while off. What have i done wrong...
  11. S

    22hp Briggs Carb Problem

    You are correct. Apparently it had fallen out and was lost. A new one and o-ring will be here tomorrow. I'll let you know how it goes.
  12. S

    22hp Briggs Carb Problem

    I'm working on a friends 22hp Briggs 44N677-0005-G1. At first it was a needle valve problem and was leaking gas by and filling the cylinders and crankcase with gas. I took the carb off and replace the needle valve, float and gasket. While it was off I cleaned the passages with carb cleaner...
Top