Recent content by wfsway

I understand, the pins #54 are the same dimensions, anyway I have used proper diameter brush (cheap Harbor Tool) approximately 5-6mm to just clear shiny metal of the hole. I cannot Imagine it being beyond interference fit ? The Honda shop manual (attached) does not detail any special treatment...

The new pin will slip into the axle easily (no press needed), the wheel ratchet then keeps it confined when you install the wheels. It is only when they rust they become difficult ! Also hope you found more housing seals. I also prime & paint the new axle just after the housings to help the...

The #54 pin will need to be soaked in penetrating oil, you could also cut one side flush providing less to drive through. Removal is done securely in vise with properly sized punch and hammer. Additionally heat could be applied to help expansion movement. The welding of the axle pieces would...

Thank you so much for the detailed information, this tells and shows me exactly what to do. Your attention to detail and obvious love for these fine mowers is rare. I want to know more about your developing post so to follow you. I can also tell you have studied the service manuals and data, you...

That is a very nice machine, you have kept it very well. I am curious about how you used the 1" PVC on the rear wheel. I have my original light grey and they have some cracking. My machine was literally pulled from the trash and in flood zone. I attached the photo of original where I started and...

Here is another set of axle adjusters that I reworked. These bearings were for Honda Baja and worked even better. I finished the adjuster close tolerance and put both items in the freezer, then press fit for the final result.

Fine work my friend, I know how much is involved there. Check out the Honda thread Walk Behind Restoration HR215 SXA.

Robert, I just purchased the shop manual with Supplements Y & Z from Honda Power Equipment. I was concentrating on the transmission and maybe missed the piston ring details ? Also I have rebuilt the rear axle adjusters with sealed bearings, so far they are working great. This is the only...

Yes I will try that with the engine serial number, I was preparing to order some parts to begin after mowing season. I do work on the mowers in the evenings, I have learned so much and enjoy productive activity. I also rebuild vintage trimmers such as Shindaiwa, McCulloch anything higher quality...

Hey Folks Update to thread, starting another Restoration. I found 1994 Masters 5.0 to begin new restoration. The SX transmission was almost ruined so presently pulled apart and checked changed fluid and will need weld repair to the axle shaft. Just confirming full functionality.

Forum, I am new to this site and wanted to share my experience and efforts to restore the titled subject. I am Quality Engineer by trade and explains why I am so detailed and meticulous about this restoration, and was great experience to learn about this fine equipment piece by piece. Presently...