I have just bought this series 8 model 28108e second hand. can get it start and run, but i put my volt meter on the battery and there is no charge at all. 12.8 volts, no change no matter where the throttle is. after looking at the parts page i do not see anything as far as diodes anywhere. how does this thing supposed to charge?
Should read close to 14volts , you need to look at the wires from magneto to voltage regulator - should read 30 plus into the Voltage regulator , from there should read around 14 volts to the battery.
There is a procedure on Utube to lay it out for you if you do a search.
its defiantly a B&S L series Single piston engine, as to which one, hard to say the previous owner replaced the recoil housing and it has no engine tag anymore. but i have a similar engine without a starter setup, and besides the starter the engine pretty identical. slightly different carb, but that's about it.
#5
StarTech
IF it is the original engine.
IPL list four possible stators but no regulator listed so that kinda narrows it down to either a DC only or a Dual Circuit stator.
