I have a I think a 2010 Simplicity Prestige 4 wheel drive, power steering, with 50" deck. I had the main drive belt break, and am working on replacing this. There is a large spring on the idler pulleys and I was wondering if anyone knew what the other end of this attached to. Right now it was routed to a hole in the frame and it just doesn't look right due to its rubbing on a hydrostatic line. Could anyone confirm where this spring attaches? The parts breakdown doesn't do a very good job showing this.
Thanks for the response Mark. You noticed to it was cutting into that hydro line to, yes I was concerned about that, like your idea allot. This was from the spring hooked into a hole in the side frame.
Mark,
I've seen that diagram and it does look like it hooks in the side frame and that's where I pulled it from. I was concerned it was incorrect seeing it was rubbing so badly on that hydro line. Guess I'm going to leave it like that and take your tip in covering it with some rubber tube. Thanks for the help!