Installed new drive belt on my PM152Z and while I had the wheels off I adjusted the brakes as the manual instructs. The next day I warmed up hydralics and adjusted the drive wheels to not creep or turn. Later I adjusted the control levers to be even with each other and that's when everything went sideways. I probably went about this in the wrong order but now I can't get my mower to turn over. I don't think I am getting a neutral on both levers to allow it to start. How do i get the levers adjusted to get back to a position where I can get the machine to fire up?
Any suggestions?
On the mower end of the lever when in the park position they will be depressing a plunger on a switch.
Some can be very hard to find hidden inside frame channels out of the way .
Find the switch
MAke sure the plungers are depressed and the plug on the back is secure.
Remove the plug, spray you favourite goop into the socket then replace & remove it a few times to clean the contacts
If it is loose, bend the contacts in a bit
On some I have to put a small self tapper into the end of the plunger to get it to travel far enough to activate the switch