A while back I posted about problems I was having getting my "new" (refurbished) 4 cycle trimmer to start...got GREAT advice, and eventually I got it to start.
Every time I try to use it, however, it is still a beast to start. Today I had to crank and crank and crank it for nearly ten minutes before it finally fired. This is typical, and it is frustrating.
- I prime it as required
- I hold the throttle down
- I use the electric starter, not the pull start
The instructions say to start it on position 1 until it fires (and dies), then to move the choke to position 2, and it should start. For me, it will try to start (fire) on position 1, but when I move to position 2, it just cranks and cranks.
It runs fine once it starts. I haven't tried to restart it after it's warm; I am always afraid to kill the engine with the job half done.
Sometimes I smell gas, which makes me think I could be flooding it somehow.
Ideas?
FYI, here's the thread I had before
http://www.lawnmowerforum.com/small-engine-mower-repair/14287-my-new-sort-trimmer-wont-start.html