valley ranch
Member
- Joined
- Jan 3, 2015
- Threads
- 6
- Messages
- 26
Greetings, I'd like to hear what you think.
I'm building a band mill, you know a sawmill. I planed to use a Kohler Magnum 18 engine.
I planed to, with the engine runing take off 1/16" from the shaft so I can use a 1" centrifugal clutch. to turn the band shaft, this has been done before with other engines.
Question: Is the shaft case hardened?
Any other thoughs on this idea.
Thanks Richard
I'm building a band mill, you know a sawmill. I planed to use a Kohler Magnum 18 engine.
I planed to, with the engine runing take off 1/16" from the shaft so I can use a 1" centrifugal clutch. to turn the band shaft, this has been done before with other engines.
Question: Is the shaft case hardened?
Any other thoughs on this idea.
Thanks Richard